(Std) Yamaha FZ6 2004/-08 Tail Tidy/ Fender Eliminator-Standard Indicator
This Tail Tidy retains the original indicators and is fitted with a micro LED licence plate light
Kit Contents:
1x Instruction Sheet
2x Stickers
1x Small Stick on Reflector
8x Cable Ties
2x Female Bullet Connectors
2x Male Bullet Connectors
1x Spare LED Bulb
4x 6mm Washers
4x 6mm Bolts
2x Large Cable Ties
Fitting Instructions:
(Do not shorten the LED wires)
1. Remove the seat
2. Remove the side pod on the gear lever side
3. Disconnect the number plate light and the indicator wire ( 1x black terminal, 1x grey terminal and 2x bullet connectors)
4. Undo and remove the bolt on the underside of the gear lever side plastic exhaust shroud
5. Unclip the two zip ties holding the numberplate and indicator wires
6. Remove the plastic cap that cover the wires
7. Remove the original fender
8. Transfer the indicators to the new tail tidy - if the plastic inserts are hard to fit into the rubber - smear a little washing up liquid around them
9. Attach the new tail tidy
10. Connect the new numberplate wires as follows: - Black-Black and Red - Red/Blue
11. Reverse step 6-1
12. Check all of the electrics work correctly
Click Here to download in Adobe PDF format.
