(Std) Kawasaki ZX6RR-ZX636 2003/4,Z750-1000 2003/4/5/6 Tail Tidy/Fender Eliminator,Standard Indicator
This Tail Tidy uses standard indicators and is fitted with a micro LED licence plate light
Kit Contents:
1x Instruction Sheet
2x Stickers
6x Cable Ties
1x Stick on Reflector
2x Female Bullet Connectors
2x Male Bullet Connectors
1x Spare LED Bulb
4xM6 Washers
4x 6mm Flange Nuts
2x M6 "Bighead" studs
2x Large 6mm washers
Fitting Instructions:
1. Remove rear seat cover and seat
2. Remove the two screws at back of bike, on top surface of tail unit.
3. Remove the six push-stop lugs which hold rear seat cowl to under-tray (Located underneath tail unit flanks) To remove these, press the centre and remove the entire fastener
4. Remove Rear seat cowl.
5. Remove Black tool tray (only one screw to remove).
Remove wires to the right of the rear seat and disconnect all four connectors.
7. Remove the four screws holding the under-tray to the centre of the subframe- this will allow complete removal of the tail unit.- go ahead and remove it.
8 Remove the two bungee hooks (Keep the two black nipples for use in a moment)
9. Place the two large 6mm washers on the bracket studs and locate the new bracket using the two rear holes through the under-tray, and fasten using the nuts supplied- the two big head studs locate in the front two holes, these are purely blanking plugs.
10 Crimp the two terminals to the number-plate light wires.
11. Take the wires from the bracket number-plate light and feed up through the central hole in the under-tray, and connect them to the number-plate light wires.
12. Replace the two black nipples which were removed along with the bungee hooks.
13 Fit the indicators to the new bracket.
14. Route the cables as they were and fix them in place.
15. Test unit for correct operation of indicators and number-plate light (if you find that the number-plate light doesn't work, reverse the wires.
16. Re-assemble tail unit of bike by reversing the dismantling procedure described above.
Click Here to download in Adobe PDF format.
