(Std) Suzuki SV650S/N 05-08,SV1000N 04-08, SV1000S 05-08 Tail Tidy/Fender Eliminator, Standard Indicator.
This Tail Tidy uses the machines standard indicators and licence plate light.
Kit Contents:
1x Tail Tidy Bracket
1x Mini Reflector Sticker
1x Sealing Plate
2x Evotech Stickers
(Neoprene pads + 2 x M3 screws fitted)
Fitting Instructions:
Please allow yourself a reasonable time to fit this item although fitting the bracket is not difficult, it will take time.
1. Remove the plastic covers at the sides of the petrol tank.
2. Remove the front and pillion seats, the grab rail, battery and toolkit.
3. Undo the pillion seat release cable from the subframe (1 screw) and detatch.
4. Remove the tail unit. (4 large screws, 4 plastic clips).
To remove the 4 plastic fasteners underneath the panel press the centre with a screwdriver and pull the whole fastener out. Disconnect rear light connector - the whole thing comes off in one piece-however you may find it easier to split the tail unit at the front joint.
5. Undo and remove the four bolts that hold the undertray in place (2 bolts each side of the subframe) and pull the undertray down, exposing 4 bolts securing rear fender.
6. Disconnect indicators and number plate light. Undo 4 bolts holding fender to subframe and remove the original plastic fender.
7. Swap indicators, number plate light and number plate onto new tail tidy bracket.
8. Lay the sealing plate onto the top rear of the undertray with the NEOPRENE SIDE FACING DOWN.
9. Slide the new numberplate bracket into place and secure using original 4 fender bolts. Push the undertray upwards, locate and screw the sealing plate to the main Tail Tidy using the 2x 3mm screws.
10. Reverse steps 5-1. Taking care to check all fasteners and electrics.
Click Here to download in Adobe PDF format.
