(Std) Kawasaki Z750 / Z1000 2007/8 Tail Tidy - Standard Indicator
New for 2007, following the theme of our new generation Mono Arm Tail Tidy brackets. The main arm being CNC machined from a single piece of billet Aluminium and finished in a satin black powder coating. This tail tidy / fender eliminator fits both the Z750 and the Z1000 2007 models. Designed for use with the original indicators, Comes complete with LED numberplate light, all fixings and instructions.
Thanks to Robspeed Motorcycles in Grimsby for the loan of the development machine.
Kit Contents:
1x Instruction Sheet
2x Stickers
6x Cable Ties
1x Stick on Reflector
2x Female Bullet Connectors
2x Male Bullet Connectors
1x Spare LED Bulb
2x M6x35 Socket screws
4x 6mm Flange Nuts
2x M6x16 Socket screws
2x Black Acetal spacers
2x M4x8 C/sunk Screws (black)
Fitting Instructions:
1. Remove pillion seat/cowl
2. Remove front seat- pull catch -cable loop
3. Remove the four screws located around the top of the tail unit.
4. Remove the small panel between front and rear seat positions by sliding forward.
5. Remove the six plastic plugs located around the undertray, these are awkward and the centre needs to be pulled whilst unscrewing the centre.
6.Remove the Tail unit sides.It is easier if the rear of the front side panels is sprung out first- they are on rubber plugs.
7. Remove the pillion seat catch plate-2 screws
8. Lift out the ECU to gain access to two screws.
9. Remove the rear fender/mudguard. Two screws from top and two nuts /bolts. Two plastic plugs-again tricky, but pull out. Disconnect indicators and numberplate light.
10. Fit indicators to tail tidy bracket and assemble tail tidy.
11. Fix tail tidy to bike using bolts supplied, 2 spacers to rear bolts.
12. Connect indicators. Connect numberplate light using connectors supplied. Use cable ties to tidy wiring.
13. Check lights all work and reassemble, reversing steps 8-1. Check all fasteners
Click Here to download in Adobe PDF format.
