(Std) Kawasaki ER6 2006/7/8 Tail Tidy / Fender Eliminator - Standard Indicator
This Tail Tidy uses the standard Indicators and is equipped with a micro LED licence plate light
This machine is also known as the "Ninja 650" in the US
Kit Contents:
1x Instruction Sheet
2x Stickers
1x Stick on Reflector
5x Cable Ties
2x Female Bullet Connectors
2x Male Bullet Connectors
1x Spare LED Bulb
4x 6mm Nuts
2x Thick Spacers
2x Thin Spacers
Fitting Instructions:
(Do not shorten the LED wires)
1. Remove the seat.
2. Undo and remove the four screws that hold the OE fender in position.
3. Remove the indicators (if stock ones are to be used) and fit them to the Tail Tidy.
4. Route the wires through the slot/hole in the Tail Tidy.
5. Crimp the two terminals to the bikes numberplate light wires.
6. Attach the Tail Tidy to the bike, thick spacers to rear-longer studs.
7. Connect the wires - test unit for correct operation of indicators and numberplate light (if you find that the
number plate light does not work, reverse the wires - LED's are polarity sensitive
