Honda CBR600RR 2005/06- Tail Tidy Fender/ Eliminator
This Tail Tidy includes an LED licence plate light and will accept standard or our aftermarket indicators.
Thanks to GP Honda (Wheels) of Grimsby for the loan of the development machine
Kit Contents:
2 x Evotech Stickers
1 x Reflective Sticker
4 x Spacers
2 x Female Bullet Connectors
6 x Cable Ties
1 x Spare LED Bulb
4 x M6x20 Hex s/s screws
4 x M6 s/s Washers
2 x Male Bullet Connectors
Fitting Instructions:
1. Remove rear pillion seat/cowl.
2. Remove the front seat
3. Remove the two screws that fasten the rear of the petrol tank cover.
4. Remove the two side plastic sections
5. Remove the plastic tail section - four screws.
6. Remove the rear fender assembly.
7. Transfer the indicators to the new tail tidy.
8. Crimp the new connectors to the numberplate light wires - connect them to the numberplate light side of the original plug (you will find it easier than trying to crimp them on the bike).
9. Plug the new LED light into the connectors and check that it works - if it doesn't, unplug and reverse the wires.
10. Zip tie the wires along the inside of the tail tidy using the small holes.
11. Bolt the new tail tidy in place using the screws and washers supplied. The aluminium washers should be placed between the arms of the tail tidy and the subframe.
12. Plug the indicators in.
13. Reverse steps 1-5.
14. Check that the electrics all work correctly.
