Honda CBR1000RR Fireblade 2006/07- Tail Tidy/ Fender Eliminator
This Tail Tidy includes an LED licence plate light and will accept standard or our aftermarket indicators.CNC Machined from lightweight Aluminium, bolts directly into place using original mountings, All fittings and Instructions supplied.
Kit Contents:
1x Instruction Sheet
2x Male Bullet Connectors
4x M6 x 20 S/S Hex Screws
4x M6 Washers
2x Plastic Spacers
6x Zip Ties
2x Female Bullet Connectors
1x Reflector
1x Number plate holder with LED light
1x Spare Bulb
Fitting Instructions:
(Do not shorten the LED wires)
1. Remove rear pillion seat/cowl.
2. Remove the front seat.
3. Remove the plastic tail section - four screws.
4. Remove the rear fender assembly.
5. Transfer the indicators to the new tail tidy.
6. Crimp the new connectors to the numberplate light wires - connect them to the numberplate light side of the original plug (you will find it easier than trying to crimp them on the bike)
7. Plug the new LED light into the connectors and check that it works - if it doesn't, unplug and reverse the wires.
8. Zip tie the wires along the inside of the tail tidy using the small holes.
9. Bolt the new tail tidy in place using the fasteners supplied. If using the stock exhaust, on the gear lever side of the bike, position the two plastic spacers between the subframe and the tail tidy at the mounting points.
10. Plug the indicators in.
11. Reverse steps 5 - 1.
12. Check electrics work correctly.
Click Here to download in Adobe PDF format.
